MQC Fusion CommDock

5.00 out of 5 based on 2 customer ratings
(2 customer reviews)

$12.00$15.00

The Fusion CommDock is an all-in-one TPU printed solution for mounting all of your communications systems vertically and cleanly into the rear of your MQC Fusion airframe. It provides two SMA holes for your VTX to mount through (taking the stress off of the board-side connection) and two mount points for antenna tubes (not included) to accommodate today’s most popular receiver types at a 45 degree seperation.

The CommDock is now available in three sizes! The stock 30mm version will fit all stock kits purchased from our site or any of our distributors. The 25mm “Low Rider” CommDock still allows you to vertically mount smaller vtx/receiver combos, while the 20mm Slammed version skips the vertical mounting in exchange for mounting horizontally using the accessory rails on the back of your Fusion.

You can also now choose from the dual SMA version or the single SMA (Unify VTX) version.

Installing this solution is as easy as sliding it down over the rear standoffs and locking the bottom tab into the slot on the mid-plate of the airframe. A single wire tie can then be used to secure the components to the mount. This allows a user to reach both the binding button on the receiver and the VTX channel buttons/screen on the transmitter without having to dig through wires or squeeze through tight spaces.

Clear
SKU: MQC-FUSION-COMMDOCK Categories: , ,

Description

SPECIFICATIONS:
Dry Weight: 6g
Designer: MQC

INCLUDED
CommDock printed in TPU

2 reviews for MQC Fusion CommDock

  1. 5 out of 5

    (verified owner)

    Just awesome!! Great way to mount VTX and RX!! Great design and printing. After running this, I don’t think I would want to have a Fusion without it.

  2. 5 out of 5

    (verified owner)

    Very Clean way to mount VTX and RX. Its totally worth the extra $15-$12 for your fusion build!!!

Only logged in customers who have purchased this product may leave a review.